Right click on the network you just joined and hit ‘Properties’.Open the menu where you join WiFi networks/view the network you’re connected to.Do you want to see the password so you can get on from other devices without doing this process? Sure! Follow these simple steps: Finally, select the targeted network from before and hit ‘Next’.Now you’re happily connected to that WiFi network you just penetrated.Under ‘Which setup method do you want to use?’, select “Enter the PIN from my access point” and enter the PIN next to your network in the scan section back in the previous scan results.Under ‘What do you want to do?’, select ‘Join a wireless network’ and hit ‘Next’.In the previous area ‘Connect using Jumpstart’, hit the ‘Start JumpStart’ button.Remember the ‘Pin’ corresponding to your network in the scan results, this will be needed for later. Select the network you wish to penetrate.In the area ‘Show default pin’, select ‘All networks’ isntead of ‘Only known networks’.Don’t open it, just select the ‘Jumpstart’ folder and click ‘OK’) (By default, it installs in C:Program Files (x86)Jumpstart. In the area that says ‘Connect using JumpStart’, hit ‘Browse’ to select the location of where you installed JumpStart in the previous set-up steps. After it completes the scan, go over to the ‘Wps’ tab.In the ‘Networks’ tab, select the network adapter you wish to use.
It’ll be in Spanish, so go to the far right tab and select ‘English’ in between the other two options.Your programs are set up and ready to go, now begin the process:
0 kommentar(er)
